Details of this Paper

NETW206 Final Exam Latest 27 August 2014




Question 3. 3. (TCO 1) _____ control(s) which end devices are allowed to communicate on the network. (Points: 5);The access layer;Business goals;Collapsed core;Convergence;Question 4. 4. (TCO 1) _____ will determine the design requirements for a network. (Points: 5);Business goals;Personal preference;Location;None of the above;Question 5. 5. (TCO 1) Which of the following illustrates properly designed hierarchical networks that achieve near-wire speed among all devices? (Points: 5);Collapsed core;Convergence;The core layer;Performance;Question 6. 6. (TCO 2) Startup configuration is stored in ________. (Points: 5);ROM;PRAM;NVRAM;Flash;Question 7. 7. (TCO 2) The average amount of data that is actually transmitted as opposed to the rating of the port is _____. (Points: 5);source MAC address;switch fabric;throughput;unicast transmission;Question 8. 8. (TCO 2) _____ is a Layer 2 identifier for the frame's originating NIC or interface. (Points: 5);Propagation delay;Source MAC address;Switch fabric;Throughput;Question 9. 9. (TCO 2) _____ is a dedicated connection between two hosts. (Points: 5);Half-duplex communication;Latency;Microsegment;Multicast transmission;Question 10. 10. (TCO 2) A _____ is a frame that is sent from one host and addressed to one specific destination. (Points: 5);source MAC address;switch fabric;throughput;unicast transmission;Question 11. 11. (TCO 3) Extended-range VLANs are identified by a VLAN ID between which of the following ranges? (Points: 5);1,000-9,000;1,006-4,094;1,006-2,094;1,000-4,094;Question 12. 12. (TCO 3) A _____ VLAN is a VLAN that is configured to carry only user-generated traffic. These VLANs are sometimes referred to as user VLANs. (Points: 5);data;default;native;none of the above;Question 13. 13. (TCO 3) Which VLANs are allowed over the link when a new trunk link is configured on an IOS-based switch? (Points: 5);All defined VLANs are allowed on the trunk by default.;Each VLAN, or VLAN range, that is specified with the switchport mode command;Each VLAN, or VLAN range, that is specified with the vtp domain command;Each VLAN, or VLAN range, that is specified with the VLAN database command;Question 14. 14. (TCO 3) Which would not be one of the characteristics of a typical VLAN? (Points: 5);VLANs logically divide a switch into multiple, independent switches at Layer 2.;Trunk links can carry traffic for multiple VLANs.;VLAN implementation significantly increases traffic due to added trunking information.;A VLAN can span multiple switches.;Question 15. 15. (TCO 3) Which of the following configures the port to negotiate a trunk? (Points: 5);Switchport mode trunk;Switchport mode dynamic desirable;Switchport nonegotiate;Switchport mode access;1. (TCO 3) Which of the following best describes the mapping between VLANs and IP subnets in a modern switched network? (Points: 5);One VLAN to many IP subnets;One IP subnet to one VLAN;One IP subnet to many VLANs;Varies with the model of Cisco Catalyst switch;Question 2. 2. (TCO 3) Which of following VLAN frame encapsulation types are configurable on a Cisco switch? (Points: 5);VTP;802.1Q;LLC;None of the above;Question 3. 3. (TCO 4) Which of the following depicts a VTP domain? (Points: 5);Switches share VLAN information, the boundary is defined by a Layer 3 device.;It can only create, delete, and modify local VLANs.;It advertises VLAN configuration information and can create, delete, and modify VLANs.;It restricts broadcast traffic to those trunks that must be used to reach the destination devices.;Question 4. 4. (TCO 4) A _____ stores VLAN information only in RAM. (Points: 5);VTP client;VTP domain;VTP pruning;VTP server;Question 5. 5. (TCO 4) Which VTP mode should a Cisco switch be set to if this switch is to add or delete VLANs to a management domain? (Points: 5);Transparent;Server;Auto;Client;Question 6. 6. (TCO 5) Which of the following is the closest to the root bridge? (Points: 5);Root port;Spanning Tree Protocol;Spanning-tree algorithm;Switch diameter;Question 7. 7. (TCO 5) What is the time spent in the listening and learning states called? (Points: 5);Forward delay;Forwarding state;Hello time;Learning state;Question 8. 8. (TCO 5) The time between each BPDU sent on a port is called which of the following? (Points: 5);Forwarding state;Hello time;Learning state;Listening state;Question 9. 9. (TCO 5) A term for when the port is administratively shut down is _____. (Points: 5);designated ports;disabled state;forward delay;forwarding state;Question 10. 10. (TCO 5) In the _____ state, the MAC address table is built but does forward user data frames. (Points: 5);forwarding;hello time;learning;listening;Question 11. 11. (TCO 5) Which contains a priority value and the MAC address? (Points: 5);Bridge priority;Bridge protocol data unit;Designated ports;Bridge ID;Question 12. 12. (TCO 6) VLAN is a logical group of ports, usually belonging to _____ to control the size of the broadcast domain. (Points: 5);a single IP subnet;multiple IP subnets;either a single IP subnet or to multiple IP subnets;none of the above;Question 13. 13. (TCO 6) Which command is used to determine whether inter-VLAN communication is functioning? (Points: 5);show vlan;ping;ipconfig;show interface;Question 14. 14. (TCO 6) Inter-VLAN routing _____ additional subnet broadcast addresses. (Points: 5);requires;does not require;sometimes requires;none of the above;Question 15. 15. (TCO 6) How many physical interfaces are required to perform inter-VLAN routing with traditional inter-VLAN routing? (Points: 5);One port per VLAN;Two ports per VLAN;Four ports per VLAN;No physical interface per VLAN


Paper#66409 | Written in 18-Jul-2015

Price : $32